1、陈述原假设H₀和备择假设H₁，确定进行检验的显著性水平α；

* State H₀ and H₁.Determine the level of significance α.

2、确定检验的方向性，需要注意的是ANOVA检验总是单尾检验；

* Determine the directionality of the test. Notice: the ANOVA test is always a single tail test.

3、指出检验的自由度df，注意在ANOVA检验中有两个自由度，分别是组间变异的自由度（k-1）和组内变异的自由度（N-k），其中k为设置水平数，N为总的样本容量；

* Indicate the degree of freedom of the test. Notice: there are two degrees of freedom in the ANOVA test, namely the degree of freedom of inter-group variation (k-1) and the degree of freedom of intra-group variation (N-k), where k is the number of setting levels and N is the total sample capacity.

4、根据组间自由度、组内自由度以及显著性水平α，查表找出临界F统计量的值；

* Find the critical F statistic by looking up the table according to inter-group degrees of freedom, intra-group degrees of freedom and significance level α.

5、对于样本计算F统计量的值，画出如下图所示的方差分析表 * Calculate the F value of your sample, and draw the ANOVA table as shown in the figure above.

6、比较计算得出的F值和临界F值，如果F<F_crit，则接受原假设H₀，如果F>F_crit，则拒绝H₀，接受备择假设H₁；

* Compare the calculated F value with the critical F value.If F_obs < F_crit，then accept the null hypothesis; if not, then refuse it and accept the alternative hypothesis.

7、进行事后检验。

* Carry out the post hoc test.